PIC16F916-I/ML【PDF 26/229 页】IC PIC MCU FLASH 8KX14 28QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3862

22页 23页 24页 25页 [26页]27页 28页 29页 30页

206

8018P–AVR–08/10

ATmega169P

20.2.5

Start Condition Detector

The start condition detector is shown in Figure 20-6 on page 205 The SDA line is delayed (in the

range of 50 to 300 ns) to ensure valid sampling of the SCL line. The start condition detector is

only enabled in Two-wire mode.

The start condition detector is working asynchronously and can therefore wake up the processor

from the Power-down sleep mode. However, the protocol used might have restrictions on the

SCL hold time. Therefore, when using this feature in this case the Oscillator start-up time set by

the CKSEL Fuses (see ”Clock Systems and their Distribution” on page 30) must also be taken

into the consideration. Refer to the ”Bit 7 – USISIF: Start Condition Interrupt Flag” on page 207

for further details.

20.2.6

Clock speed considerations.

Maximum frequency for SCL and SCK is f_CK /4. This is also the maximum data transmit and

receieve rate in both two- and three-wire mode. In two-wire slave mode the Two-wire Clock Con-

trol Unit will hold the SCL low until the slave is ready to receive more data. This may reduce the

actual data rate in two-wire mode.

20.3

Alternative USI Usage

When the USI unit is not used for serial communication, it can be set up to do alternative tasks

due to its flexible design.

20.3.1

Half-duplex Asynchronous Data Transfer

By utilizing the Shift Register in Three-wire mode, it is possible to implement a more compact

and higher performance UART than by software only.

20.3.2

4-bit Counter

The 4-bit counter can be used as a stand-alone counter with overflow interrupt. Note that if the

counter is clocked externally, both clock edges will generate an increment.

20.3.3

12-bit Timer/Counter

Combining the USI 4-bit counter and Timer/Counter0 allows them to be used as a 12-bit

counter.

20.3.4

Edge Triggered External Interrupt

By setting the counter to maximum value (F) it can function as an additional external interrupt.

The Overflow Flag and Interrupt Enable bit are then used for the external interrupt. This feature

is selected by the USICS1 bit.

20.3.5

Software Interrupt

The counter overflow interrupt can be used as a software interrupt triggered by a clock strobe.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式